Connecting The Projector To Ac Power With A Pluggable Type B Connection - Christie CP2420-Xe Installation And Setup Manual

If required, use a 90° strain relief connector to route the power cable downward.
4. Connect the AC supply to the terminal block.
Connect the ground first to reduce the risk of electrical shock.
A
B
C
5. Replace the knockout plate and the bottom access panel over the terminal block.
Connecting the projector to AC power with a
pluggable type B connection
Learn how to connect the projector to AC power with a pluggable type B connection.
When connecting the projector to AC power, follow all electrical codes for your location. In addition,
follow these recommendations:
• Use a 30-32A, double-pole, UL-listed wall circuit breaker. It must be part of the building
installation and easily accessible.
• Use 10AWG or 8AWG wiring.
• When using 10AWG cables, the distance between the wall circuit breaker and the projector
must not exceed 20 m (65.6 feet).
• When using 8AWG cables, the distance between the wall circuit breaker and the projector
must not exceed 30 m (98.4 feet).
• The socket-outlet must be installed near the equipment and must be easily accessible. The
plug can be used as the device disconnect.
Follow these steps to connect the projector to AC power with a pluggable type B connection:
1. On the bottom of the projector in the front right corner, loosen the two screws and slide the
plate forward to expose the terminal block.
2. Remove the four screws located in the bottom right corner of the front bezel.
3. Connect AC power to the terminal block, beginning with the ground lead first.
Tighten the screws securely.
CP2420-Xe and CP4420-Xe Installation and Setup Guide
020-103555-01 Rev. 1 (03-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
N
L
Ground
Installing and setting up
29