Table of Contents
Advertisement
EDID reset
3.3.3. EDID mode
EDID mode is active when the EDID button is illuminated on the front panel. To
enter or to exit from this mode press and release the EDID button.
There are three submenus in this mode, use the RIGHT, LEFT and ENTER buttons
to reach them.
EDID view
You can select an EDID with the UP and DOWN buttons and view it's short name.
The short name contains the three-character long manufacturer code (so called
PNPID), the resolution and frame rate of the preferred timing, detailed timing and
the model name descriptor string. The following EDIDs can be selected:
O1 - O32
I1 - I32
M1 - M50
M51 - M100
EDID save
Lightware matrices have 50 user programmable EDID memory slots. You can learn
and save an EDID from any output to one of the M51-M100 memory slots. You
have to select the desired output and the desired destination, then press ENTER.
The EDIDs are stored in the non-volatile emergency memory. By default all user
programmable memory slots are empty.
Press the EDID button to exit.
Page 36 / 109
Resets the EDID on all input ports to factory default.
(LWR 1920x1200@59.55Hz UniversalEDID)
EDID memory location
EDID short name
The EDID of the currently attached or the last attached
sink device.
The emulated EDIDs of the input ports.
The stored Lightware EDIDs.
50 user programmable memory slots.
Source
Destination
EDID short name
Advertisement
Table of Contents
