Table of Contents
Advertisement
3.2.5. VIEW crosspoint state
User can check the current switching status on the front panel using front panel
buttons. View mode is slightly different in TAKE or AUTOTAKE modes because of
different switching philosophy of the two modes.
Info:
View mode does not mean, that the router has to be switched in different modes,
viewing and switching can be done after each other, without pressing any special
buttons.
View current state in TAKE mode
If the router is in TAKE mode, user can verify both input and output connections. In
TAKE mode no accidental change can be done unless TAKE button is pressed.
Press and release a source button. Now the selected source button and all
destination buttons that are currently connected to the selected source will light up.
This informative display will remain active for 5 seconds, then all buttons turn unlit.
If every source, destination and TAKE button is unlit (the unit is in TAKE mode, and
no input was selected in the last 5 seconds), press and release a destination
button to see its current state. Now the source button, which is connected to the
selected destination, will light up. If no source button is illuminated, the selected
destination is in muted state. Upon pressing another destination button, the last
state of the destination can be seen.
View current state in AUTOTAKE mode
In AUTOTAKE mode only states of destinations can be viewed.
Press and release the required destination button. Now the source button, which is
connected to the selected destination, will light up. If no source button is
illuminated, the selected destination is in muted state. Upon pressing another
destination button, the last state of the destination can be seen.
3.2.6. VIEW live inputs and attached monitors
1.
2.
3.
Press and release SOURCE PRESENT button.
Input buttons will light up indicating that active TMDS clock signal is present
on respective input connectors.
Output buttons will light up indicating that a powered monitor is attached to
the output. The output circuit senses TMDS pull-up resistors on monitor side.
Press and release SOURCE PRESENT button to quit this mode.
MX32x32DVI-HDCP-Pro and HDMI-Pro
User's Manual v1.0
Page 31/ 109
Advertisement
Table of Contents
