Mx-Hdmi-Tp-Ib - Lightware MX32x32HDMI-Pro User Manual

2.5.3. MX-HDMI-TP-IB

12V DC power
This 8-channel HDMI input card is equipped with two RJ45 connectors per each
input. The card has exactly the same capabilities as the MX-DVI-HDCP-IB
described above in section 2.5.1. There are three status LEDs next to every input,
which indicate the following (from bottom to top):
SCDT
HDMI
HDCP
During the booting process the state of these LEDs is undetermined.
Connectors
Signal reclocking
DVI support
HDMI support
Audio
HDCP
Signal monitoring
Processing
EDID emulation
The pin assignment for the RJ45 connectors can be found on page 23. The
maximum cable lengths are specified on page 25.
This card is compatible with the following Lightware products:
For further details on these devices, please visit the http://www.lightware.eu
webpage.
Page 14 / 109
RJ45 connectors (Video and DDC)
Valid video signal is detected and sync can be extracted.
If this LED illuminates, the incoming signal is HDMI. If it
does not illuminate then the incoming signal is DVI.
It illuminates red when the incoming signal is content
protected and HDCP encrypted.
8 HDMI Type A connectors
Yes
Up to 165MHz pixel clock, single link only
HDMI 1.3 compliant
Up to 225MHz pixel clock
16, 24, 30 and 36 bits/pixel are supported
RGB, YUV 4:4:4 and YUV 4:2:2 modes
PCM (up to 192 kHz and 8 channels), Dolby, DTS, MLP,
Dolby True-HD and DTS-HD Master Audio support
HDCP 1.3 compliant
The same as described above in section 2.5.1
Color range compression or expansion
256-byte E-EDID
DVI-HDCP-TP-TX100
HDMI-HDCP-TP-TX100
MX-HDMI-TP-OB (see 2.6.3.)
DVI-TP-TX200 (DVI signals only, HDCP is not supported)
MX-DVI-TP-OB card (DVI signals only, HDCP is not supported)
Status LEDs Card active LED