Table of Contents
Advertisement
2.6.4. MX-OPT-HDMI-OB
Status LEDs
This 8-channel optical output card is fully compatible with the HDMI 1.3 and HDCP
1.3 standards. This card uses Lightware's Single Fiber Technology, which
eliminates the need for additional copper cables.
Main features:
Connectors
Cable type
HDMI
HDCP
There are four status LEDs next to every input, which indicate the following (from
bottom to top):
LED0
HDMI
HDCP
LASER active
This card is compatible with the following Lightware products:
HDMI-OPT-RX300
MX-HDMI-OPT-IB (see 1.1.1.)
DVI-OPT-RX100 (DVI signals only, HDCP is not supported)
DVI-OPT-RX200 (DVI signals only, HDCP is not supported)
MX-DVI-OPT-IB-NT card (DVI signals only, HDCP is not supported)
MX-DVI-OPT-IB-R-LC card (DVI signals only, HDCP is not supported)
Optical connectors
(Can be ordered with NT, LC, ST or SC connectors)
8x LC or 8x SC or 8x ST or 8x Neutrik NO2-4FD type
50/125 multimode fiber
HDMI 1.3 compliant
Up to 225MHz pixel clock
16, 24, 30 and 36 bits/pixel are supported
RGB, YUV 4:4:4 and YUV 4:2:2 modes
PCM (up to 192kHz and 8 channels), Dolby, DTS, MLP,
Dolby True-HD and DTS-HD Master Audio support
HDCP 1.3 compliant
Reserved
It illuminates green when the port operates in HDMI
mode
It illuminates green when HDCP encryption is active.
It illuminates red when laser beam is detected.
MX32x32DVI-HDCP-Pro and HDMI-Pro
User's Manual v1.0
Card active LED
Page 19/ 109
Advertisement
Table of Contents
