Clean Gantry Rails - Oce Arizona 250 GT User Manual

Clean Gantry Rails

Clean Gantry Rails
Introduction
Dust and debris can accumulate on the gantry rails, which run along the length of the
table. The bearings that run on the rails are equipped with shields that are designed
to keep debris from entering the bearing housing. After a period of time and use,
debris can accumulate on the outside of the bearing shields as the gantry travels
along the table.
When to do
If you notice any dirt or ink on the gantry rails, or an accumulation of debris on the
rails bearings, clean them immediately.
Required tool
Poly-Wipe lint-free Cloth
Attention: In the event of an ink spill on the rail, it should be cleaned
immediately, before the bearings have a chance to run over the spill. After the
area has been cleaned, wipe the spill area again thoroughly with a
water-moistened lint-free cloth to remove any chemical residue before running
the gantry over the area again. Slight ink stains that remain on the rail after
cleaning are not a major problem.
How to Clean the Rails
Power OFF the printer at the AC power On/Off switch located at the side of the
1.
electronics enclosure.
Turn the switch to the horizontal Lockout position and apply a lock.
2.
Use a dry lint-free cloth to remove all visible debris that has accumulated next to the
3.
bearing shields. It is only necessary to clean the outside bearing shields. When
removing debris always wipe away from the shields.
Remove the lock from the Lockout switch.
4.
Power ON the printer.
5.
118 Chapter 8 Printer Maintenance