Table of Contents
Advertisement
Understanding the printer menus
PCL Emul menu
Use
Font Source
Resident
Disk
Download
Flash
All
Font Name
Courier 10
Symbol Set
10U PC‑8
12U PC‑850
PCL Emulation Settings
Point Size
1.00–1008.00
PCL Emulation Settings
Pitch
0.08–100
PCL Emulation Settings
Orientation
Portrait
Landscape
To
Specify the set of fonts used by the Font Name menu.
Notes:
•
"Resident" is the factory default setting. Resident shows the factory
default set of fonts downloaded in the RAM.
•
"Flash" and "Disk" settings show all fonts resident in that option.
•
The flash option must be properly formatted and cannot be read/write‑,
write‑, or password‑protected.
•
"Download" shows all the fonts downloaded in the RAM.
•
"All" shows all fonts available to any option.
Identify a specific font and the option where it is stored.
Note: Courier 10 is the factory default setting. Courier 10 shows the font
name, font ID, and the storage location in the printer. The font source
abbreviation is R for Resident, F for Flash, K for Disk, and D for Download.
Specify the symbol set for each font name.
Notes:
•
10U PC‑8 is the US factory default setting. 12U PC‑850 is the international
factory default setting.
•
A symbol set is a set of alphabetic and numeric characters, punctuation,
and special symbols. Symbol sets support the different languages or
specific programs such as math symbols for scientific text. Only the
supported symbol sets are shown.
Change the point size for scalable typographic fonts.
Notes:
•
12 is the factory default setting.
•
Point size refers to the height of the characters in the font. One point
equals approximately 0.014 inch.
•
Point sizes can be increased or decreased in 0.25‑point increments.
Specify the font pitch for scalable monospaced fonts.
Notes:
•
10 is the factory default setting.
•
Pitch refers to the number of fixed‑space characters per inch (cpi).
•
Pitch can be increased or decreased in 0.01‑cpi increments.
•
For nonscalable monospaced fonts, the pitch appears on the display but it
cannot be changed.
Specify the orientation of text and graphics on the page.
Notes:
•
Portrait is the factory default setting. Portrait prints text and graphics
parallel to the short edge of the page.
•
Landscape prints text and graphics parallel to the long edge of the page.
118
Hide quick links:
Advertisement
Table of Contents
