Paper and specialty media guide
Adjust the width guides to fit the width of the envelopes.
Before loading the envelopes on the tray, flex and fan the envelopes to loosen them. Straighten the edges on a
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal envelopes.
Tips on using labels
From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the labels
loaded in the tray.
Print samples on labels being considered for use before buying large quantities.
Use labels designed specifically for laser printers.
Do not use labels with slick backing material.
Do not use labels with exposed adhesive.
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and toner cartridge
Before loading labels on the tray, flex and fan labels to loosen them. Straighten the edges on a level surface.
Note: Vinyl and polyester labels are supported only in the MS710 Series printer models.
Tips on using transparencies
From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the
transparencies loaded in the tray.
Print a test page on the transparencies being considered for use before buying large quantities.
Use transparencies designed specifically for laser printers.
Avoid getting fingerprints on the transparencies to prevent print quality problems.
Before loading transparencies, flex and fan the sheets to prevent them from sticking together.
When printing on large volumes of transparencies, make sure to print by batches of only up to 20 with an interval
of at least three minutes between batches, to prevent the transparencies from sticking together in the bin. You can
also remove transparencies from the bin by batches of 20.
The following paper characteristics affect print quality and reliability. Consider these factors before printing on them:
The printer trays and multipurpose feeder can automatically feed paper weights between 60–176 g/m
long paper. The 2100‑sheet tray can automatically feed paper weights up to 60–135 g/m
Paper lighter than 60 g/m
Note: Two‑sided printing is supported for 60–176 g/m
(16 lb) might not be stiff enough to feed properly, and may cause jams.
(16–36‑lb) grain long paper.