Understanding the printer menus
PCL Emul menu
PCL Emulation Settings
Establish the font search order.
Resident is the factory default setting.
This menu item is available only when a formatted flash memory card is
installed and operating properly.
Make sure the flash memory card is not read/write‑, write‑, or
Job Buffer Size must not be set to 100%.
Specify the set of fonts used by the Font Name menu.
"Resident" is the factory default setting. "Resident" shows the factory
default set of fonts downloaded in the RAM.
"Download" shows all the fonts downloaded in the RAM.
"Flash" shows all fonts resident in that option. The optional flash memory
card must be properly formatted and cannot be read/write‑, write‑, or
"All" shows all fonts available to any option.
Identify a specific font and the option where it is stored.
Note: Courier 10 is the factory default setting. Courier 10 shows the font
name, font ID, and the storage location in the printer. The font source
abbreviation is R for Resident, F for Flash, and D for Download.
Specify the symbol set for each font name.
10U PC‑8 is the US factory default setting. 12U PC‑850 is the international
factory default setting.
A symbol set is a set of alphabetic and numeric characters, punctuation,
and special symbols. Symbol sets support the different languages or
specific program, such as math symbols for scientific text. Only the
supported symbol sets are shown.
Change the point size for scalable typographic fonts.
12 is the factory default setting.
Point size refers to the height of the characters in the font. One point
equals approximately 0.014 inch.
Point sizes can be increased or decreased in 0.25‑point increments.