Dell B5460dn User Manual page 105

Understanding the printer menus
Use
Timeouts
Hibernate Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Do Not Hibernate
Hibernate
Timeouts
Screen Timeout
15–300 sec
Timeouts
Print Timeout
Disabled
1–255 sec
Timeouts
Wait Timeout
Disabled
15–65535 sec
To
Set the printer to operate at a low power state.
Notes:
•
When the Hibernate Timeout timer expires, the printer uses
Ethernet connection to check the value of "Hibernate
Timeout on Connection."
•
If "Hibernate Timeout on Connection" is set to "Do Not
Hibernate," then the printer never automatically hibernates.
•
If "Hibernate Timeout on Connection" is set to "Hibernate,"
then the printer follows the Hibernate Timeout value, except
when it is set to Disabled.
•
"3 days" is the factory default setting.
Set the printer to follow the setting of "Hibernate Timeout" even
when an active Ethernet connection exists.
Notes:
•
"Hibernate" is the factory default setting.
•
If "Hibernate Timeout on Connection" is set to "Do Not
Hibernate," then the printer never automatically hibernates.
• If "Hibernate Timeout on Connection" is set to "Hibernate,"
then the printer follows the value of the "Hibernate
Timeout" setting, except when it is set to Disabled.
Set the amount of time in seconds the printer waits before
returning the display to the Ready state.
Note: "30 sec" is the factory default setting.
Set the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print
job.
Notes:
•
"90 sec" is the factory default setting.
•
When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Set the amount of time in seconds the printer waits for additional
data before canceling a print job.
Notes:
• "40 sec" is the factory default setting.
•
Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
105