Download  Print this page
Also See for B5460dn
User manual - 233 pages
Datasheet - 8 pages
Manual - 2 pages

Advertisement

Table of Contents
Understanding the printer menus
Use
NPA Mode
On
Off
Auto
Serial Buffer
Disabled
Auto
3K to [maximum size allowed]
Job Buffering
Off
On
Auto
Protocol
DTR
DTR/DSR
XON/XOFF
XON/XOFF/DTR
XONXOFF/DTRDSR
To
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
Auto is the factory default setting. Auto sets the printer to examine data,
determine the format, and then processes it appropriately.
When set to On, the printer performs NPA processing. If the data is not in NPA
format, it is rejected as bad data.
When set to Off, the printer does not perform NPA processing.
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Set the size of the serial input buffer.
Notes:
Auto is the factory default setting.
Disabled turns off job buffering. Any jobs already buffered on the disk are
printed before normal processing is resumed.
The serial buffer size setting can be changed in 1‑KB increments.
The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
To increase the maximum size range for the Serial Buffer, disable or reduce
the size of the parallel, serial, and network buffers.
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Temporarily store print jobs on the printer hard disk before printing.
Notes:
Off is the factory default setting. The printer does not buffer print jobs on the
printer hard disk.
On buffers print jobs on the printer hard disk.
Auto buffers print jobs only if the printer is busy processing data from another
input port.
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Select the hardware and software handshaking settings for the serial port.
Notes:
DTR is the factory default setting.
DTR/DSR is a hardware handshaking setting.
XON/XOFF is a software handshaking setting.
XON/XOFF/DTR and XON/XOFF/DTR/DSR are combined hardware and
software handshaking settings.
97

Advertisement

Table of Contents

   Related Manuals for Dell B5460dn

Comments to this Manuals

Symbols: 0
Latest comments: