Adjusting Sleep Mode - Dell B5460dn User Manual

Saving money and the environment
Use
On
Off
3
Press .

Adjusting Sleep mode

To save energy, decrease the number of minutes before the printer enters Sleep mode. Select from 1 to 120. The factory
default setting is 30 minutes.
Note: The printer still accepts print jobs when in Sleep mode.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
• View the printer IP address in the TCP/IP section in the Network/Ports menu. The IP address appears as four
sets of numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Navigate to:
Settings > General Settings > Timeouts
3
In the Sleep Mode field, enter the number of minutes you want the printer to wait before it enters Sleep mode.
4
Click Submit.
Using the printer control panel
1
From the printer control panel, navigate to:
> Settings >
2
In the Sleep Mode field, select the number of minutes you want the printer to wait before it enters Sleep mode.
3
Press .
> Settings > > General Settings >
To
Reduce printer noise.
Notes:
• Print jobs process at a reduced speed.
•
Printer engine motors do not start until a document
is ready to print. There is a short delay before the
first page is printed.
• The alarm control and cartridge alarm sounds are
turned off.
•
The printer ignores the Advance Start command.
Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
> Timeouts > > Sleep Mode >
125