Understanding the printer menus
View Signal Quality
View Security Mode
Note: This menu appears only in printer models that are connected to an Ethernet network or when an optional
wireless network adapter is installed.
To access the menu, navigate to either of the following:
Network/Ports > Standard Network > Standard Network Setup > AppleTalk
Network/Ports > Network [x] > Network [x] Setup > AppleTalk
[list of zones available on the network]
Standard USB menu
Select an available network for the printer to use.
View the quality of the wireless connection.
View the encryption method for the wireless network.
Enable or disable AppleTalk support.
Note: Yes is the factory default setting.
Show the assigned AppleTalk name.
Note: The AppleTalk name can be changed only from the Embedded Web
Show the assigned AppleTalk address.
Note: The AppleTalk address can be changed only from the Embedded Web
Provide a list of AppleTalk zones available on the network.
Note: The default zone for the network is the factory default setting.
Set the printer to automatically switch to PCL emulation when a print job received
through a USB port requires it, regardless of the default printer language.
On is the factory default setting.
When set to Off, the printer does not examine incoming data. The printer uses
PostScript emulation if the PS SmartSwitch is set to On. It uses the default
printer language specified in the Setup menu if the PS SmartSwitch is set to