Download  Print this page

Restore Held Jobs; Some Held Jobs Were Not Restored - Dell B5460dn User Manual

Laser printer.
Hide thumbs
Also See for B5460dn
User manual - 233 pages
Datasheet - 8 pages
Manual - 2 pages

Advertisement

Table of Contents
Troubleshooting
Replace unsupported imaging unit [32.xy]
Remove the imaging unit, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's
Guide.
Note: If you do not have a replacement imaging unit, then visit our Web site or contact the place where you
purchased the printer.

Restore held jobs?

Do either of the following:
Select Restore on the printer control panel to restore all held jobs stored in the printer hard disk.
Select Do not restore if you do not want any print jobs to be restored.
Serial port [x] disabled [56]
Try one or more of the following:
From the printer control panel, select Continue to clear the message.
The printer discards any data received through the specified serial port.
Select Reset active bin to reset the active bin for a linked set of bins.
Make sure the Serial Buffer menu is set to Enabled.

Some held jobs were not restored

From the printer control panel, select Continue to clear the message and continue printing.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
Turn off the printer and then turn it back on.
Standard USB port disabled [56]
Try one or more of the following:
From the printer control panel, press
Note: The printer discards any data received through the USB port.
From the printer control panel, set USB Buffer to Auto.
to clear the message and continue printing.
179

Advertisement

Table of Contents

   Related Manuals for Dell B5460dn

Comments to this Manuals

Symbols: 0
Latest comments: