Table of Contents
Advertisement
Loading paper and specialty media
Loading paper and specialty media
The selection and handling of paper and specialty media can affect how reliably documents print. For more information,
see
"Avoiding jams" on page 145
Setting the paper size and type
1
From the printer control panel, navigate to:
> Settings >
2
Press the up or down arrow button to select the tray or feeder, and then press
3
Press the up or down arrow button to select the paper size, and then press
4
Press the up or down arrow button to select the paper type, and then press
Configuring Universal paper settings
The Universal paper size is a user‑defined setting that lets you print on paper sizes that are not preset in the printer
menus.
Notes:
•
The smallest supported Universal size is 70 x 127 mm (2.76 x 5 inches) for one‑sided printing and
105 x 148 mm (4.13 x 5.83 inches) for two‑sided (duplex) printing.
•
The largest supported Universal size is 216 x 356 mm (8.5 x 14 inches) for one‑sided and two‑sided printing.
•
When printing on paper less than 210 mm (8.3 inches) wide, the printer may print at a reduced speed after a
period of time to ensure the best print performance.
From the printer control panel, navigate to:
> Settings >
> Paper Menu >
measure >
Loading the 550‑sheet tray
CAUTION—POTENTIAL INJURY: To reduce the risk of equipment instability, load each tray separately. Keep all
other trays closed until needed.
1
Pull out the tray.
Notes:
•
When loading folio‑, legal‑, or oficio‑size paper, lift the tray slightly and pull it out completely.
•
Avoid removing trays while a job prints or while Busy appears on the display. Doing so may cause a jam.
and
"Storing paper" on page
> Paper Menu >
> Paper Size/Type >
> Universal Setup >
61.
.
to change the settings.
> Units of Measure >
.
> select unit of
39
Hide quick links:
Advertisement
Table of Contents
