Table of Contents
Advertisement
DOLOMITE STEP UP
1.
1.
Width adjustment
Lay the platform support down and remove screws
with an Allen key No. 6. Adjust the side frame to
the required width. Replace the screws and tighten
them with a minimum of10 Nm.
Repeat the procedure on the other side
The right and left side of the frame must
always be adjusted in/out by an equivalent
amount.
Be aware of the risk of getting fingers
pinched when adjusting the side frame!!
2. Brakes
Press down the outer edge of the brake caliper until
a click is heard and the wheel is locked.
Two of the wheels must be locked before
the user is assisted to or from the support
platform.
DOLOMITE STEP UP' can be adjusted in
three widths.
4
Preparation
.
Product features
3
2
1
2.
3.
3. Charging the electric motor
Allow the battery to charge for 24 hours before the
platform support is used for the first time.
There are two lights on the battery; (A) shines yellow
when the battery is charging. (B) shines green when
the motor is in use.
When the battery capacity is low, a warning signal
sounds indicating that it is time to charge the battery.
We recommend that the battery is charged regularly,
e.g. every night, for maximum service life.
Connect the mains cable to the control unit and the
mains socket. The yellow light (A) indicates that the
battery is charging. When the battery is fully charged,
charging ceases automatically.
Ensure that the emergency stop is not pushed
in when the motor is to be charged.
The H-shaped lower frame has the same
dimensions in the front and back. Adjust the
width so that the platform can negotiate the
most narrow passage in the premises.
A
B
Advertisement
Table of Contents
