DRIVE CHAIN SLACK ADJUSTMENT
AIR BLEEDING/
j. Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 mSkg)
NOTE:
If bleeding is difficult, it may be necessary to let
the brake fluid settle for a few hours.
Repeat the bleeding procedure when the tiny
bubbles in the brake system have disappeared.
k. Fill the brake fluid reservoir to the proper lev-
el.
Refer to "BRAKE FLUID LEVEL INSPEC-
TION".
WARNING
Check brake operation after bleeding the
brake system.
***************************************
SR304093
DRIVE CHAIN SLACK ADJUSTMENT
NOTE:
Before checking and adjusting, rotate the rear
wheel several revolutions and check the slack
at several points to find the tightest point. Check
and if necessary adjust the drive chain slack
with the rear wheel in this "tightest" position.
CAUTION:
Too little chain slack will overload the en-
gine and other vital parts; keep the slack
within the specified limits.
WARNING
S Securely support the motorcycle so that
there is no danger of it falling over.
S Stand the motorcycle on its centerstand.
3-22
INSP
ADJ