OR
IMPORTANT INFORMATION
EB101030
LOCK WASHERS/PLATES AND COTTER
PINS
1. Replace all lock washers/plates and cotter
pins after removal. Bend lock tabs along the
bolt or nut flats after the bolt or nut has been
tightened to specification.
EB101040
BEARINGS AND OIL SEALS
Install bearings and oil seals so that the
manufacturer's marks or numbers are visible.
When installing oil seals, apply a light coating of
lightweight lithium base grease to the seal lips.
Oil bearings liberally when installing, if ap-
propriate.
1 Oil seal
CAUTION:
Do not use compressed air to spin the bear-
ings dry. This will damage the bearing sur-
faces.
1 Bearing
EB101050
CIRCLIPS
1. Check all circlips carefully before reassemb-
ly. Always replace piston pin clips after one
use. Replace distorted circlips. When instal-
ling a circlp 1 , make sure that the sharp-
edged corner 2 is positioned opposite the
thrust 3 it receives. See sectional view.
4 Shaft
1-3
GEN
INFO