Starter Clutch Inspection - Yamaha SR125 1997 Service Manual

CDI MAGNETO AND STARTER CLUTCH
YP401081
C.D.I. MAGNETO REMOVAL
1. Remove:
: Bolt 1 (magneto)
: Plain washer 2
NOTE:
: Loosen the bolt (magneto) 1 while holding
the rotor with a sheave holder 3 .
: Do not allow the sheave holder to touch the
projection on the magneto.
Sheave holder:
90890-01701
2. Remove:
: CDI magneto assembly 1
: Woodruff key
NOTE:
Remove the magneto using sheave holder 2 ,
rotor puller 3 and rotor puller attachment 4 .
Rotor puller:
90890-01080
Rotor puller attachment:
90890-04052
SR402163

STARTER CLUTCH INSPECTION

1. Check:
: Starter clutch operation
Push the dowel pins to the arrow direction.
Unsmooth operation ! Replace.
***************************************
Checking steps:
: Hold the starter clutch.
: When turning the starter wheel gear clockwise
a , the starter clutch and the starter wheel
gear should be engaged.
: If not, the starter clutch is faulty. Replace it.
: When turning the starter wheel gear counter-
clockwise b , it should turn freely.
: If not, the starter clutch is faulty. Replace it.
***************************************
2. Inspect:
: Dowel pins 1
: Compression springs 2
: Spring caps 3
Wear/Damage ! Replace.
4-47
ENG