Yamaha SR125 1997 Service Manual page 73

TIRE INSPECTION
2. Inspect:
: Tire surfaces
Wear/damage
Minimum tire tread depth
(front and rear): 1.6 mm
1 Tread depth
2 Side wall
3 Wear indicator
WARNING
: It is dangerous to ride with a worn-out tire.
When the tire tread begins to show signs of
wear, replace the tire immediately.
: Patching a punctured tube is not recom-
mended. If it is absolutely necessary to do
so, use great care and replace the tube as
soon as possible with a good quality re-
placement tube.
: Do not use tubeless tires on a wheel de-
signed for tube type tires only. Tire failure
and personal injury may result from sud-
den deflation.
Tube type wheel
Tubeless type wheel T beless type wheel
: Be sure to install the correct tube when us-
ing tube type tires.
: After extensive tests, the tires listed below
have been approved by Yamaha Motor Co.,
Ltd. for this model. No guarantee concern-
ing handling characteristics can be given if
a tire combination other than one ap-
proved by Yamaha is used on this motor-
cycle. The front and rear tires should al-
ways be by the same manufacturer and of
the same design.
WARNING
After mounting a tire, ride conservatively for
a while to give the tire time to seat itself
properly in the rim. Failure to do so could
lead to an accident with possible injury to
the rider or damage to the motorcycle.
2. After a tire repair or replacement, be sure to
tighten the valve stem locknut 1 to specifi-
cation.
Locknut:
1.5 Nm (0.15 m:kg)
3-27
INSP
ADJ
Replace.
Tube type tire only
Tube type or yp
tubeless tire.