Yamaha SR125 1997 Service Manual page 214

ELECTRICAL STARTING SYSTEM
7-18
6. Measure:
: Brush spring force
Fatigue/out of specification ! Replace as a
set.
Brush spring force:
540 X 660 g
7. Inspect:
: Oil seal
Wear/damage ! Replace.
YP******
Assembly
Reverse the "Disassembly" procedure.
Note the following points.
1. Install:
: Brush holder 1
NOTE:
Align the lib on the brush holder with the slot a
on the bracket, before assembly.
2. Install:
: Washer set 1
: Armature coil 2
3. Install:
: Ring 1
New
: Stator assembly 2
: Washer set 3
: Front bracket
NOTE:
: Apply molybdenum grease lightly on to the
bearings of the starter motor.
: Align the match marks on the yoke with the
match marks on the brackets.
ELEC
3 Nm (0.3 m:kg)