Special Tools - Yamaha SR125 1997 Service Manual

EB102000

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use only
the appropriate special tools; this will help prevent damage caused by the use of inappropriate tools or
improvised techniques.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
90890-01080 Rotor puller
90890-04052 Attachment
This tool is used when removing or installing
the meter gear bush.
90890-01083 Rocker arm shaft puller bolt
90890-01084 Weight
These tools are used when removing or
installing the rocker arm shafts.
90890-01268 Ringnut wrench
This tool is used to loosen and tighten the
exhaust and steering ringnut.
90890-01311 Valve adjusting tool
This tool is necessary for adjusting valve
clearance.
90890-01312 Fuel level gauge
This gauge is used to measure the fuel level
in the float chamber.
90890-01367 Fork seal driver weight
90890-01400 Fork seal driver attachment (ø30 mm)
This tool is used when installing the fork seal.
90890-01403 Ring nut wrench
This tool is used to loosen and tighten the
steering ring nut.
90890-01701 Sheave holder
This tool is used for holding the secondary
sheave.
90890-01996 Cylinder cup installer set
This tool is used for installing the cylinder
cup to the master cylinder piston.
SPECIAL TOOLS
Tool name/Usage
1-6
GEN
INFO
Illustration