Yamaha SR125 1997 Service Manual page 111

CLUTCH
3. Install:
:Lock washer 1
: Nut 2 (clutch boss)
NOTE:
Install the clutch boss nut 2 while holding the
clutch boss with a clutch holding tool 3 .
Clutch holding tool:
90890-04086
4. Bend:
: Lock washer tab
(along a flat side of the end)
5. Install:
: Friction plate 1
: Clutch plate 2
NOTE:
: Install the clutch plates and friction plates al-
ternately on the clutch boss, starting with a fric-
tion plate and ending with a friction plate.
: Coat all clutch and friction plates with engine
oil before installation.
6. Install:
: Push rod #2
: Ball
7. Install:
: Push rod #1 1
: O-ring 2
New
: Push plate 3
: Plate washer 4
: Nut 5 (push rod #1)
8. Install:
: Pressure plate 1
: Compression springs 2
: Bolts 3 (clutch springs)
NOTE:
Tighten the clutch spring bolts in stage, using a
crisscross pattern.
4-31
ENG
New
70 Nm (7.0 m:kg)
6 Nm (0.6 m:kg)