Uninstalling The Mxd-701; Removing The Mxd-701 From Its Backbox - AMX Modero X Series G5 MXT-2001-PAN Instruction Manual

Installing Wall-Mount (MXD) Panels
6.
To reattach the panel to its Backbox, repeat the installation procedure.
For further information, refer to the video available at www.amx.com (go to
Newsroom > Videos > Touch Panels).

Uninstalling the MXD-701

The MXD-701 is held in place to the Backbox via latch hooks and clips on the Backbox.
In certain circumstances, such as firmware updates or other maintenance that requires accessing the device's USB port,
the device may need to be removed from the Backbox. The clips that lock down the MXD-701's bottom edge
(Landscape) or right edge (Portrait) may be unlatched in order to remove the device from the mounting surface.

Removing the MXD-701 From Its Backbox

1.
The MXD-701 has three rows of ventilation holes along the molding (FIG. 47):
FIG. 49 MXD-701 Molding (highlighted in blue)
2.
On the bottom (Landscape) or right side (Portrait) of the MXD-701, locate the fifth ventilation holes from each
edge, on the row closest to the Backbox (FIG. 48): .
Access hole
FIG. 50 Bottom View (Landscape) or Right-Side View (Portrait) of the MXD-701 showing access holes in molding
3.
With a stout, strong point (a push pin or straightened paper-clip, for example), carefully press into the access holes
in either end of the molding until the snap is disconnected.
54
#5
Molding
Panel (surface)
Modero X® Series G5 Touch Panels Instruction Manual
Molding
Access hole
#5