AMX Modero X Series G5 MXT-2001-PAN Instruction Manual page 45

3.
Thread the incoming power and Ethernet wiring from their terminal locations through the surface opening
(FIG. 30).
Note that FIG. 30 shows the MXD-1901-PAN, but the illustration applies equally to the MXD-2001-PAN. Also
note that FIG. 30 shows a landscape panel but the installation of a portrait panel is essentially the same, other than
the vertical orientation.
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
Wall
4X Installation Clamp
for Wall Thickness
.37 [12.01] to .98 [25.0]
Note:
Additional detailed installation and product drawings are available to view/download at www.amx.com
FIG. 30 MXD-1901-PAN Backbox installation (Landscape)
4.
Remove any knockouts as needed on either long dimension of the Backbox to facilitate incoming wiring and pull
the wiring through the resultant holes.
5.
Push the Backbox into the wall opening. Insure that the locking tabs lie flush against the Backbox, and that the
Backbox goes freely into the opening.
6.
Extend the locking tabs on the sides of the Backbox by tightening the screws inside the box until snug.
The maximum recommended torque to screw in the locking tabs on the plastic
Backbox is 5 IN-LB [56 N-CM]. Applying excessive torque while tightening the tab
screws, such as with powered screwdrivers, can strip out the locking tabs or damage
the plastic Backbox.


Modero X® Series G5 Touch Panels Instruction Manual
8X Knock Outs
Remove For Cable
Routing As Needed
Not all of the tabs must be extended to lock the Backbox in place, but extending a minimum of the top and
bottom tabs is highly recommended.
Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs
will tighten up against the inside of the wall.
Installing Wall-Mount (MXD) Panels
Cables Routed to
Wall Opening
Mounting screws
placement (optional)
39