AMX Modero X Series G5 MXT-2001-PAN Instruction Manual page 46

Installing Wall-Mount (MXD) Panels


7.
Insert each connector into its corresponding location along the back of the device (FIG. 31).
Ethernet 10/100 Port
FIG. 31 MXD-2001-PAN / MXD-1901-PAN - rear connectors
Refer to the Power via 12 VDC section on page 41 for details on wiring a power
connection.
8.
Test the incoming wiring by attaching the panel connections to their terminal locations and applying power. Verify
that the panel is receiving power and functioning properly to prevent repetition of the installation.
Do not disconnect the connectors from the touch panel. The unit must be installed
with the attached connectors before being inserted into the drywall.
Configurations that use the limited access USB port on the side of the connector box
may require a right angle mating connector (not included) for connection to the
device.
9.
Insert the four temporary mounting posts of the panel into the openings on the Backbox and slide the panel onto the
Backbox (FIG. 32). This will temporarily hold the panel during the rest of the installation.
Note that FIG. 32 shows the MXD-1901-PAN, but the illustration applies equally to the MXD-2001-PAN. Also
note that FIG. 32 shows a landscape panel but the installation of a portrait panel is essentially the same, other than
the vertical orientation.
40
The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,
as well as in assisting with removal if necessary.
For additional strength, #4 mounting screws (not included) may be secured through circular holes located at
the left and right sides of the MXD-2001-PAN (see FIG. 30). In order to prevent damage to the touch panel,
make sure that these are flush with the Backbox.
12 VDC Power Port
Type A USB Port
(limited access)
Modero X® Series G5 Touch Panels Instruction Manual