Mxt-1001 / Mxt-701; Connector Locations - Mxt-1001/Mxt-701; Power Via 12 Vdc; Wiring A 12Vdc Power Connection - AMX Modero X Series G5 MXT-2001-PAN Instruction Manual

Installing Tabletop (MXT) Panels

MXT-1001 / MXT-701

Detailed specifications drawings for the

Connector Locations - MXT-1001/MXT-701

Two Type A USB ports are located on the rear right corner of the panel (FIG. 17). USB peripherals (i.e. mouse,
keyboard) may be connected to either of the two USB ports on the rear of the device. Updates to the device's firmware
can also made via the USB ports (see Upgrading Firmware via USB Flash Drive on page 57 for details). Note that
FIG. 17 shows the MXT-1001, but the USB ports are in a similar location on the MXT-701.
FIG. 17 MXT-1001 - rear view
Refer to the Power via PoE section on page 31 for details on PoE and Ethernet Cable
Installation and Modification.

Power via 12 VDC

The MXT-2001-PAN and MXT-1901-PAN use a 12 VDC-compliant power supply to provide power to the panel via the
2-pin 3.5 mm captive wire PWR connector. The incoming PWR and GND wires from the power supply must be
connected to the corresponding locations within the PWR connector.
Connecting power to the panel should be done using the included 2-pin 3.5mm
captive wire connector included with the device. This connector is retained within its
port with locking screws instead of the pins on each side of standard captive wire
connectors, and using force to insert a standard captive wire connector may damage
the device.

Wiring a 12VDC Power Connection

To use the 2-pin 3.5 mm captive wire connector with a 12 VDC-compliant power supply, the incoming PWR and GND
wires from the external source must be connected to their corresponding locations on the connector (FIG. 18). The
connector uses locking screws to insure a connection to the device, so make sure to insert and tighten the screws before
applying power.
PWR +
GND -
To the Touch Panel
FIG. 18 NetLinx power connector wiring diagram
1.
Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm captive wire cable.
Match the wiring locations of the +/- on both the power supply and the terminal connector.
2.
Tighten the clamp to secure the two wires.
30
MXT-1001
USB Ports Entry for RJ45/PoE Cable
and MXT-701 are available to download from www.amx.com.
Power Supply
Modero X® Series G5 Touch Panels Instruction Manual