Uninstalling The Mxd-1001; Removing The Mxd-1001 From Its Backbox - AMX Modero X Series G5 MXT-2001-PAN Instruction Manual

Uninstalling the MXD-1001

The MXD-1001 is held in place via latch hooks and clips in the Backbox.
In certain circumstances, such as firmware updates or other maintenance that requires accessing the device's USB or
Micro-USB ports, the device may need to be removed from the Backbox.
The clips that lock down the MXD-1001's bottom edge (Landscape) or right edge (Portrait) may be unlatched in order to
remove the device from the mounting surface.

Removing the MXD-1001 From Its Backbox

1.
The MXD-1001 has three rows of ventilation holes along the molding (FIG. 47):
FIG. 47 MXD-1001 Molding (highlighted in blue)
2.
On the bottom (Landscape) or right side (Portrait) of the MXD-1001, locate the seventh and eight ventilation holes
from each edge, on the row closest to the Backbox (FIG. 48): .
Access holes
FIG. 48 Bottom View (Landscape) or Right-Side View (Portrait) of the MXD-1001 showing access holes in molding
3.
With a stout, strong point (i.e. push pin or straightened paper clip), carefully press into the access holes in either end
of the molding until the snap is disconnected.
To facilitate the disconnection, grasp the bottom of the panel (Landscape) or right side (Portrait) and pull gently
outward until the side of the panel is free of the snap. Use your other hand to hold stable the front of the touch panel.
Always pull on the frame of the touch panel. NEVER pull on the glass edge.
4.
When the first side is free, repeat the process with the other.
5.
With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait) to remove
the touch panel from the Backbox. Be careful not to pull on the cables or connectors.
Modero X® Series G5 Touch Panels Instruction Manual
#7, #8
Installing Wall-Mount (MXD) Panels
Molding
Panel (surface)
Molding
Access holes
#8, #7
53