AMX Modero X Series G5 MXT-2001-PAN Instruction Manual page 70

Upgrading Firmware
FIG. 62 NetLinx Studio v3.4 or higher - Send To NetLinx Device dialog - G5 Firmware file sample
6.
Click Send to initiate the firmware file transfer. The progress of the transfer is indicated in the progress bars
7.
The Panel will display the Message "Updating System Files", then restart itself.
8.
The Installing System Update page will be displayed on the panel until the firmware upgrade process is complete.
At this point, the panel will reboot and open it's home page.
If an error occurs during this type of transfer, then the HTTP Server Transfer Error dialog is invoked (FIG. 63):
FIG. 63 NetLinx Studio v3.4 or higher - HTTP Server Error dialog
In this case, there are two options for proceeding with the firmware transfer:

64
Select Transfer the KIT File via the NetLinx Master Controller (legacy KIT file transfer method)... to
proceed using the standard (non-HTTP) method used for other NetLinx Devices (via the master controller)
when OK is clicked.
Note that depending on network speed and the size of the *.kit file, this method could take up to 20-30
minutes to complete. More specifically, timed tests indicate that it takes approximately 60 seconds per 9.5MB
of a *.kit file to transfer. The following table indicates the approximate length of time to send a *.kit file via
the legacy file transfer method:
Modero X® Series G5 Touch Panels Instruction Manual