Power Via 12 Vdc - AMX Modero X Series G5 MXT-2001-PAN Instruction Manual

4X Mounting posts
Note:
Additional detailed installation and product drawings are available to view/download at www.amx.com
FIG. 32 MXD-1901-PAN installation (Landscape)
When installing the panel, do NOT press on or near the center of the panel. Too
much stress at the center may damage the touch screen surface. When installing the
panel, pressure should be applied toward the ends of the panel ONLY.
10.
Use the six provided screws, three at each end, to secure the touch panel to the Backbox.
Use only the provided screws, as other screws may damage the touch panel.
11.
Snap the decorative side covers onto each end of the panel.
12.
Reconnect the terminal Ethernet and USB cables to their respective ports.

Power via 12 VDC

The MXT-2001-PAN and MXT-1901-PAN use a 12 VDC-compliant power supply to provide power to the panel via the
2-pin 3.5 mm captive wire PWR connector. The incoming PWR and GND wires from the power supply must be
connected to the corresponding locations within the PWR connector.
Connecting power to the panel should be done using the included 2-pin 3.5mm
captive wire connector included with the device. This connector is retained within its
port with locking screws instead of the pins on each side of standard captive wire
connectors, and using force to insert a standard captive wire connector may damage
the device.
Modero X® Series G5 Touch Panels Instruction Manual
Side cover
4X Mounting post openings
6X 4-40 X 1/4" LONG FLAT HEAD
TORQUE TO 5±.2 IN LBS
Installing Wall-Mount (MXD) Panels
Side cover
41