Uninstalling The Mxd-700 - AMX MXT-700 Operation/Reference Manual

Uninstalling the MXD-700

The MXD-700 is held in place to the back box via latch hooks and clips on the back box (FIG. 21), securing it to the
mounting surface. In certain circumstances, such as firmware updates or other maintenance that requires accessing the
device's USB port, the device may need to be removed from the back box. The clips that lock down the MXD-700's
bottom edge (Landscape) or right edge (Portrait) may be unlatched in order to remove the device from the mounting
surface.
To remove an MXD-700 from its back box:
1.
The bottom (Landscape) or right side (Portrait) of the MXD-700 has a series of ventilation holes along the molding
(FIG. 21). From each end, count to the fifth holes on the center row.
FIG. 21 Underside of MXD-700
2.
With a stout, strong point (a push pin or straightened paper-clip, for example), carefully press into the access holes
in either end of the molding (FIG. 22) until the snap is disconnected. To facilitate the disconnection, grasp the
bottom of the panel (Landscape) or right side (Portrait) and pull gently outward until the side of the panel is free of
the snap. Use your other hand to hold stable the front of the touch panel.
FIG. 22 Location of access holes on MXD-700 molding
Always pull on the frame of the touch panel. NEVER pull on the glass edge.
3.
When the first side is free, repeat the process with the other.
4.
With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait) to remove
the touch panel from the back box. Be careful not to pull on the cables or connectors.
5.
To reattach the panel to its back box, repeat the installation procedure on page 20.
For further information on this procedure, please refer to the video available at the
AMXconfigure channel on YouTube: http://www.youtube.com/user/AMXconfigure
MXD/T-700 7" Modero X Series® Touch Panels
Molding
Access holes
Installation
21