AMX Modero X Series G5 MXT-2001-PAN Instruction Manual page 56

Installing Wall-Mount (MXD) Panels
FIG. 44 shows the MXD-701 Backbox installation:
FIG. 44 MXD-701 Backbox Installation (Landscape)
4.
Remove any knockouts as needed on either long dimension of the Backbox to facilitate incoming wiring and pull
the wiring through the resultant holes.
5.
Push the Backbox into the mounting surface. Insure that the locking tabs lie flush against the Backbox and that the
Backbox goes freely into the opening.
6.
Extend the locking tabs on the sides of the Backbox by tightening the screws inside the box until snug.
The maximum recommended torque to screw in the locking tabs on the plastic
Backbox is 5 IN-LB [56 N-CM]. Applying excessive torque while tightening the tab
screws, such as with powered screwdrivers, can strip out the locking tabs or damage
the plastic Backbox.




7.
Insert each connector into its corresponding location along the back of the panel.
a.
To reach the RJ45 connector, gently pull it from beneath the electronics cover.
50
#4 Screws
Note:
Additional detailed installation and product drawings are available to view/download at www.amx.com
Not all of the tabs must be extended to lock the Backbox in place, but extending a minimum of the top and
bottom tabs is highly recommended.
Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs
will tighten up against the inside of the wall.
The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,
as well as in assisting with removal if necessary.
For additional strength, #4 mounting screws (not included) may be secured through circular holes located at
the left and right sides of the panel (FIG. 43, FIG. 44). In order to prevent damage to the touch panel, make
sure that these are flush with the Backbox.
2X Installation Clamp
for Wall Thickness
.37 [12.03] to .98 [.25.0]
Modero X® Series G5 Touch Panels Instruction Manual
4X Knock-Outs
Remove for Cable
Routing as Needed