Uninstalling The Mxd-430 - AMX MXD-430 Operation/Reference Manual

If you see a gap between the panel and the back box, or feel any binding while
locking down the panel, stop immediately and verify that no cables or other items are
in the way. Do not force the panel into position, as this can cause damage to the
touch screen or the panel electronics.
13.
Reconnect the terminal Ethernet and USB to their respective locations on either the Ethernet port or NetLinx
Master.

Uninstalling the MXD-430

The MXD-430 is held in place to the back box via latch hooks and a clip on the back box (FIG. 12), securing it to the
mounting surface. In certain circumstances, such as firmware updates or other maintenance that requires accessing the
device's USB port, the device may need to be removed from the back box. The clip that locks down the MXD-430's top
edge may be unlatched in order to remove the device from the mounting surface.
To remove an MXD-430 from its back box:
1.
The top of the MXD-430 has a series of ventilation holes along the molding (FIG. 13). From each end, count to the
seventh holes on the center row.
2.
With a stout, strong point (a push pin or straightened paperclip, for example), carefully press straight into the access
holes in the center of the molding (FIG. 13) until the snap is disconnected. Grasp the top of the panel and pull gently
outward until the side of the panel is free of the snap. Use your other hand to stabilize the front of the touch panel.
FIG. 13 Location of access holes on MXD-430 molding
Always pull on the frame of the touch panel. NEVER pull on the glass edge.
3.
With the edge of the touch panel free, carefully lift down and out to remove the touch panel from the back box. Be
careful not to pull on the cables or connectors.
4.
To reattach the panel to its back box, repeat the installation procedure on page 14.
For further information on this procedure, please refer to the video available at the
AMX Configure channel on YouTube: http://www.youtube.com/user/AMXconfigure
MXD-430 4.3" Modero X Series® Wall/Flush Mount Touch Panel
Front
Access holes Snap
Installation
15