Installing Tabletop (Mxt) Panels; Mxt-2001-Pan / Mxt-1901-Pan; Connector Locations - Mxt-2001-Pan / Mxt-1901-Pan - AMX Modero X Series G5 MXT-2001-PAN Instruction Manual

Installing Tabletop (MXT) Panels

MXT-2001-PAN / MXT-1901-PAN

Detailed specifications drawings for the
www.amx.com.

Connector Locations - MXT-2001-PAN / MXT-1901-PAN

Two Type A USB ports are located on the rear right corner of the panel (FIG. 14). USB peripherals (i.e. mouse,
keyboard) may be connected to either of the two USB ports on the rear of the device. Updates to the device's firmware
can also made via the USB ports (see Upgrading Firmware via USB Flash Drive on page 57 for details). Note that
FIG. 14 shows the MXT-1901-PAN, but the USB ports are in a similar location on the MXT-2001-PAN.
FIG. 14 MXT-1901-PAN - rear view
The Power and Ethernet connectors, as well as an additional USB port are located on the bottom of the device ( FIG. 15).
Ethernet 10/100 Port
FIG. 15 MXT-2001-PAN / MXT-1901-PAN - underside connectors
Refer to the Power via 12 VDC section on page 30 for details on wiring a power
connection.
The underside USB port, as well as the two rear USB ports, may be used with a flash drive for page transfers or firmware
upgrades. The MXT-2001-PAN and MXT-1901-PAN have a slot at the base with channels for securing power and
Ethernet cables, to allow options for cable configuration (FIG. 16).
Tie-wrap channels
FIG. 16 Tie-wrap for power connector ferrite
Each channel side has slots for attaching tie-wraps to secure each cable.


Modero X® Series G5 Touch Panels Instruction Manual
MXT-2001-PAN
Type A USB Ports
Ferrite
The ferrite on the power cable must be secured with the included tie-wrap during installation to prevent the
possibility of the panel not sitting flush on the table.
Other cables may be secured with tie-wraps if desired.
and MXT-1901-PAN are available to download from
12 VDC Power Port
Type A USB Port
Tie-wrap
Installing Tabletop (MXT) Panels
29