Installing Tabletop (MXT) Panels
MXT-2001-PAN / MXT-1901-PAN
Detailed specifications drawings for the
Connector Locations - MXT-2001-PAN / MXT-1901-PAN
Two Type A USB ports are located on the rear right corner of the panel (FIG. 14). USB peripherals (i.e. mouse, keyboard) may be
connected to either of the two USB ports on the rear of the device. Updates to the device's firmware can also made via the USB
ports (see the
USB ports are in a similar location on the MXT-2001-PAN.
MXT-1901-PAN - rear view
FIG. 14
The Power and Ethernet connectors, as well as an additional USB port are located on the bottom of the device (FIG. 15).
Ethernet 10/100 Port
MXT-2001-PAN / MXT-1901-PAN - underside connectors
FIG. 15
NOTE: Refer to the Power via 13.5V section on page 32 for details on wiring a power connection.
The underside USB port, as well as the two rear USB ports, may be used with a flash drive for page transfers or firmware upgrades.
The MXT-2001-PAN and MXT-1901-PAN have a slot at the base with channels for securing power and Ethernet cables, to allow
options for cable configuration (FIG. 16).
Tie-wrap channels
Tie-wrap for power connector ferrite
FIG. 16
Each channel side has slots for attaching tie-wraps to secure each cable.
The ferrite on the power cable must be secured with the included tie-wrap during installation to prevent the possibility of
the panel not sitting flush on the table.
Other cables may be secured with tie-wraps if desired.
Modero X® Series G5 Touch Panels - Installation & Hardware Reference Manual
MXT-2001-PAN
Modero G5 Conf iguration and Programming Guide
Type A USB Ports
Ferrite
and
MXT-1901-PAN
are available to download from www.amx.com.
for details). Note that FIG. 14 shows the MXT-1901-PAN, but the
13.5V
Type A USB Port
Tie-wrap
Installing Tabletop (MXT) Panels
Power Port
31