Table of Contents
Advertisement
Installing Tabletop (MXT) Panels
MXT-2000XL-PAN / MXT-1900L-PAN
Detailed specifications drawings for the
www.amx.com.
Connector Locations - MXT-2000XL-PAN / MXT-1900L-PAN
Two Type A USB ports are located on the rear right corner of the panel (FIG. 15). USB peripherals (i.e. mouse,
keyboard) may be connected to either of the two USB ports on the rear of the device. Note that FIG. 15 shows the
MXT-1900L-PAN, but the USB ports are in a similar location on the MXT-2000XL-PAN.
FIG. 15
MXT-1900L-PAN - rear view
The Power and Ethernet connectors, as well as an additional USB port are located on the bottom of the device ( FIG. 16).
Ethernet 10/100 Port
FIG. 16
MXT-2000XL-PAN / MXT-1900L-PAN - underside connectors
Refer to the Power via 12 VDC section on page 42 for details on wiring a power
connection.
The underside USB port, as well as the two rear USB ports, may be used with a flash drive for page transfers or firmware
upgrades.
The MXT-2000XL-PAN and MXT-1900L-PAN have a slot at the base with channels for securing power and Ethernet
cables, to allow options for cable configuration (FIG. 17).
Tie-wrap channels
FIG. 17
Tie-wrap for power connector ferrite
Each channel side has slots for attaching tie-wraps to secure each cable.
Modero X® Series G4 Touch Panels Instruction Manual
MXT-2000XL-PAN
Type A USB Ports
Ferrite
The ferrite on the power cable must be secured with the included tie-wrap during installation to prevent the
possibility of the panel not sitting flush on the table.
Other cables may be secured with tie-wraps if desired.
and
MXT-1900L-PAN
are available to download from
12 VDC Power Port
Type A USB Port
Tie-wrap
Installing Tabletop (MXT) Panels
41
Advertisement
Table of Contents
