Unicast Rtp - An Overview; Unicast Tcp - An Overview - Extron electronics VNR 100 User Manual

Unicast RTP — An Overview
Similar to multicast RTP, this method uses a real-time variation of UDP protocol, called
unicast RTP. This method can be used where the network infrastructure does not support
multicast traffic. Typically, this protocol is used for point-to-point configuration (single source
to single display), but can be configured to use up to a maximum of four displays.
NOTE: The encoder sends an individual stream to each decoder. This means that the
total bandwidth of the VN-Matrix system increases as more decoders are added.
LAN-1
LAN-2
STATUS
Encoder sends data using RTP
to up to 4 specified decoders.
SOURCE
Figure 3.
RTP provides very low latency which is important for video streaming. Unlike other
protocols, RTP packets include a time stamp. If packets are received in the wrong
order, they are sorted into the correct order for display or discarded if the time stamp is
out-of-date.
However, because RTP is a connectionless protocol, data delivery is not guaranteed.
When data packets are lost (for example, due to excessive network traffic), the
decoder devices carefully manage the data stream to minimize any image disruption.
Unicast TCP — An Overview
This method transports data using standard TCP and should only be used for single
point-to-point transfer of data.
TCP is a connection-based protocol and, therefore, data is guaranteed to be delivered.
However, in the event of excessive network traffic, delivery may be delayed which will impact
real-time performance.
LAN-1
LAN-2
STATUS
Encoder
SOURCE
Figure 4.
The decoder defines which source to connect to. Other than defining an IP address and
source type (if required), no special source encoder setup is required.
-4
RTP 1
Network
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
Unicast RTP Streaming
TCP
Network
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
Unicast TCP Streaming
RTP 1
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP 2
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP 3
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP 4
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
DISPLAYS
TCP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
Decoder makes a TCP
connection with a
specified encoder.
DISPLAY
VNR 100 • Introduction 5