Front Panel Cover - Extron electronics VNR 100 User Manual

Front Panel Cover

The front panel has a lockable cover to prevent unauthorized access to the removable
drives. The cover has five light tubes that allow the signals from the front panel LEDs to be
seen when the cover is in place.
Figure 6.
To install the front cover:
1.
2.
3.
4.
5.
Figure 7.
Remove the cover by reversing these steps.
VN-Matrix
VNR 100
Recorder
VNR 100 Front Panel Cover
Ensure the Lock is in the open position (
undo the lock.
Holding the cover at a slight angle, slide the two projections on the left side of the cover
into the holes on the inside surface of the handle (
Press the release catch inwards to retract the two projections on the right side of the
cover and slide the cover into place.
Release the catch to allow the two projections to fit into the holes on the surface of the
handle.
If required, use the key to lock the cover in place.
VN-Matrix
VNR 100
Recorder
VNR 100 Front Panel Cover, installed
Light Tubes
). If necessary, use the provided key to
in figure 8, below).
A
VNR 100 • Panels and Cabling
Projections
(2 on each end)
Release Catch
Lock
Handle
9