Extron electronics VNR 100 User Manual page 19

3. Click . The VNR 100 Recorder Settings page opens:
Login
VNMatrix recorder settings
Network settings [eth0]
IP Address 192.168.254.254
Subnet Mask
255.255.255.0
Gateway 192.168.254.253
Recorder settings
Serial
1111999
192.168.254.254
Controller IP
Controller port 5432
MTU 1500
User settings
New password
Confirm New password
Data disk
Umount
mounted to /home/matrix_rec/Recording_Files
status:
Disk free space: 19GB->98% used
Format
formated to ext3
Apply Changes
Figure 11. VNR 100 Web Page
IP Address and Subnet mask — are assigned to the ETH0 NIC on the VNR100.
Gateway — is the IP address of the gateway that is assigned to the ETH0 NIC on
the VNR100. If no gateway exists, the IP address should be the same as the system
contoller.
Controller IP Address — is the IP address of the Enterprise Controller used to control
the VNR100.
Controller Port — is the port number is used by all VN_Matrix devices to communicate
with the Enterprise Controller. The value should only be changed if the Enterprise
Controller has been configured to accept communications on a different port number.
Under normal circumstances the setting should remain at the default setting (5432).
Maximum Transmission Unit (MTU) — is used to set the packet size, in bytes, that
is used to transmit data over the network. The default is 1500 bytes. This setting is
for advanced use only. Under normal circumstance do not change this value from the
default value. If the MTU value is incorrectly set, the MATRIX system may malfunction.
New password — Change the default password for the config account if required. The
User account name cannot be changed.
Data (media) disk —This area provides information about the media drive on the
VNR 100. For full instructions on replacing the media drive, please see the VNR 100
Media Drive Replacement Kit Installation Guide, at www.extron.com.
4. Enter the ,
IP Address
corresponding fields.
5. Enter the
Controller IP
transmission unit ( ) setting of the controller in the corresponding fields.
MTU
6. Enter a
New password
7. Click to save the settings (or click
Apply Changes
saving the information).
NOTE: There is no indication whether you have successfully connected to the
Enterprise Controller. To verify that the recorder has linked to the controller, you
must log on to the controller and ensure that the recorder is in the device list.
Logout
Cancel Changes
, and
Subnet Mask Gateway
address,
Controller port
and
Confirm New password
VNR 100 • Configuration and Hardware Setup
address of the recorder in the
number and maximum
in the corresponding fields.
to exit without
Cancel Changes
13