Multicast Rtp - An Overview - Extron electronics VNR 100 User Manual

Multicast RTP — An Overview
Multicast RTP allows a source to be displayed on multiple displays. This method uses RTP,
which is a real-time variation of UDP (User Datagram Protocol).
LAN-1
LAN-2
STATUS
Encoder sends data using RTP
to a multicast group.
SOURCE
Figure 2.
The source encoder uses RTP to send data to a multicast group. The source does not need
to know the IP address of the decoders that are using the source.
RTP provides very low latency which is important for video streaming. Unlike other
protocols, RTP packets include a time stamp. If packets are received in the wrong
order, they are sorted into the correct order for display or discarded if the time stamp is
out-of-date.
However, because RTP is a connectionless protocol, data delivery is not guaranteed.
When data packets are lost (for example, due to excessive network traffic), the
decoder devices carefully manage the data stream to minimize any image disruption.
RTP
Network
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
Multicast RTP Streaming
RTP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
RTP
Multiple decoders can be
part of the multicast group.
DISPLAY(S)
VNR 100 • Introduction 4