Extron electronics VNR 100 User Manual page 29

The supplied rack mount kit includes two sets of rail assemblies, six rail mounting brackets,
and mounting screws.
NOTE: The rail assemblies are specific for the left and right.
Each of the rail assemblies consists of three sections: two inner fixed rails that are secured
to the VNR 100 recorder chassis and a two-section expandable rack rail that is secured
directly to the rack. The front inner rails (right and left) are already attached to the chassis.
Attaching the rear inner rail to the VNR 100
Figure 17. Attaching the Rear Inner Rail
1. Locate the rear inner rails. Align the four square holes in the rail with the four hooks on
the side of the VNR 100.
2. Press the rail against the VNR 100 so that the hooks pass through the holes.
3. Slide the rail back so that the hooks hold the rail.
4. Secure the rail against the side of the VNR 100 using the provided M4 flat head screws
(two on each side).
Figure 18. Completed Inner Rail Assembly
2 2
1 1
Front Inner Rail
Completed Rail Assembly
VNR 100 • Reference Information
Rear Inner Rail
4 4
23