Table of Contents
Advertisement
Software-Based
Configuration and
Control
This section of the guide is divided into the following topics:
•
•
•
•
Configuration and Control: An Overview
An IPL EXP unit must be configured before use in order to recognize and accept
commands and pass them on to the controlled devices. It can be configured and controlled
via a host computer connected to the same network as the control processor (see
PoE and LAN/PoE+ (Ethernet) connectors and LEDs
about LAN port and cabling to connect the expansion interface to the network).
•
•
Configuration and Control: An Overview
Basic Setup Steps: a Guide to this Section and Other Resources
Downloading the Software and Getting Started
Troubleshooting
Configure the expansion interface by using the Global Configurator software
(GC Professional or GC Plus) (see the Extron
software requirements for GC), or program it using Global Scripter.
The default web pages embedded within the expansion interface provide a means
to view general hardware information, network settings, and, if configured, project
information. You cannot configure the expansion interface via the embedded web
pages.
IPL EXP I/O Series • Software-based Configuration and Control
starting on page 18 for details
website
for full system hardware and
LAN/
31
Advertisement
Table of Contents
Need help?
Do you have a question about the IP Link Pro xi IPL EXP I/O Series and is the answer not in the manual?
Questions and answers