Preparation For Using The Gcode Frame Translator Utility; Using Winscp And Putty - Extron electronics VNR 100 User Manual

Preparation for Using the gcode Frame Translator Utility

The gcode utility is run in a command window on the recorder where the required recording
is stored.
A command window may be opened from a remote Windows PC using WinSCP.

Using WinSCP and PuTTY

1. Open WinSCP and enter the IP address of the VN-Recorder. Use the following
parameters to log in.
• Port number
• File protocol
• User name
• Password
WinSCP Login
Session
Stored sessions
Environment
Directories
SSH
Advanced op ons
Figure 25.
2. Select
Figure 26.
By default, recordings are held in the
and the gcode Utility is located in the
only one VNRecorder directory will be present; if the recorder has been upgraded, use
the current version directory.
=
22
=
SFTP
=
matrix_rec
=
matrix
Session
Host name:
10.100.247.87
User name: Password:
matrix_rec
Private key file:
Protocol
SFTP Allow SCP fallback
File protocol:
Login
WinSCP Login
. The directory structure of the VN Recorder is displayed:
Login
1 1
2 2
VN Recorder Directory Structure
? X
Port number:
22
Select color
Save... Close
directory (see figure 26,
Recording_Files
VNRecorder_verx.y.z
VNR 100 • Reference Information
)
1
directory ( ). Usually,
2
29