Configuring Thelan Interface - peplink ONE 20 User Manual

USER MANUAL
Peplink Balance Series

10 Configuring theLAN Interface

LAN Interface settings are located atNetwork>Interfaces>LAN. Begin setting up your
physical LAN by entering IP settings (VLAN configuration will be covered following
physical LAN setup).
IP Address &
Enter the Peplink Balance's IP address and subnet mask values to be used on the LAN.
Subnet Mask
Next, choose port settings.
The default speed setting is Auto, which allows the Balance to detect and apply an
appropriate speed setting. You can also set the speed manually, as well as specify whether
Speed
the speed will be advertised on the network. Generally, advertising port speed is necessary
only when the port experiences difficulty negotiating speeds with peer devices.
IEEE 802.3ad
Link
Choose a link aggregation setting for the port or disable link aggregation here.
Aggregation
http://www.peplink.com
IP Settings
Port Settings
-77 / 258 - Copyright © 2015 Peplink