Configuring The Lan Interface(S) - peplink ONE 20 User Manual
Balance multi-wan bonding routers
For more information, please visit peplink.com
Hide thumbs
Also See for ONE 20:
- User manual (258 pages) ,
- User manual (207 pages) ,
- User manual (182 pages)
Table of Contents
Advertisement
USER MANUAL
Peplink Balance Series
12 Configuring the LAN Interface(s)
LAN Interface settings are located at Network>LAN>Network Settings. Begin setting
up your physical LAN by entering IP settings (VLAN configuration will be covered
following physical LAN setup).
Enter the Peplink Balance's IP address and subnet mask values to be used on the LAN. To
IP Address &
Subnet Mask
enable multiple VLANs, press the
If drop-in mode will be used, you can configure it in the next section.
Drop-in mode eases the installation of the Peplink Balance on a live network between the
existing firewall and router, such that no configuration changes are required on existing
Enable
equipment. Check the box to enable the drop-in mode feature.
Please refer to Section 13, Drop-in Mode for details.
WAN for Drop-
Select the WAN port to be used for drop-in mode. If WAN 1 with LAN Bypass is selected,
In Mode
the high availability feature will be disabled automatically.
http://www.peplink.com
IP Settings
button on the top right-hand corner.
Drop-in Mode Settings
-80 / 269 -
Copyright © 2016 Peplink
Advertisement
Table of Contents
