Configuring The Lan Interface(S) - peplink balance ONE User Manual
Peplink balance multi-wan bonding routers
For more information, please visit peplink.com
Hide thumbs
Also See for balance ONE:
- User manual (228 pages) ,
- Manual (2 pages) ,
- User manual (213 pages)
Table of Contents
Advertisement
USER MANUAL
Peplink Balance Series
10 Configuring the LAN Interface(s)
LAN Interface settings are located at Network>Interfaces>LAN. Begin setting up your
physical LAN by entering IP settings (VLAN configuration will be covered following
physical LAN setup).
Enter the Peplink Balance's IP address and subnet mask values to be used on the LAN. To
IP Address &
Subnet Mask
enable multiple VLANs, press the
Name
Enter the name of your network here
Inter-VLAN
Click here to enable Inter-VLAN routing on your local area network.
routing
Captive
Click here to enable Captive Portal on your local area network.
Portal
If drop-in mode will be used, you can configure it in the next section.
http://www.peplink.com
IP Settings
button on the top right-hand corner
Network Settings
-79 / 261 -
Copyright © 2015 Peplink
Advertisement
Table of Contents
