Connecting The Ac Power Cord - Eiki LC-XN200 Owner's Manual

Connecting the AC power cord

This projector uses nominal input voltages of
100–240V AC and it automatically applies to
different input voltages. It is designed to work
with a single-phase power system having a
grounded neutral conductor.
To reduce the risk of electrical shock, do not
plug into any other type of power system. If
you are not sure of the type of power being
supplied, consult your authorized dealer or
service station. Connect the projector with all
peripheral equipment before turning it on.
Note:
The AC outlet should be near this equipment
and must be easily accessible.
 Note:
For safety, unplug the AC power cord when the projector is not in use. When the projector is
connected to an outlet with AC power cord, it is in stand-by mode and consumes a little electric
power.
Note on the power cord
AC power cord must meet the requirements of the country where you use the projector. Confirm the AC
plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord
does not match, contact your sales dealer.
Projector side
To power cord
connector on your
projector.
√ Note:
Using incorrect power cord may influence the product performance, or even cause hazards like an
electric shock or fire. To ensure the product performance and security, please apply the cable of the
same model with the original one.
For the U.S.A. and
Canada
Ground
To the AC outlet.
Connect the AC power cord
(supplied) to the projector.
AC outlet side
For Continental
Europe
To the AC outlet.
Installation
For the U.K.
Ground
To the AC outlet.
23