Network Control Instructions; Lan Control - Eiki LC-XN200 Owner's Manual

Network Control Instructions

LAN control

Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, LAN cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
and computer interface will flash continuously.
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is displayed as on and obtain network address
automatically. If familiar with network, you can set DHCP as close and obtain network
address manually.
3 Enter network settings menu.
(1) Press MENU button on side control
or remote control to display screen
menu. Press  button to select
network icon.
(2) Press SELECT button on the side
control panel or  button on the
remote control to enter the network
setting.
(3) Press  button to select Network
settings and press OK/SELECT button.
(4) Press  button to set DHCP as on.
(5) Press  button to "Set" and press
OK/SELECT button."Please wait..."
appears.
Note:
When connecting to wireless network,please check the SSID/ ESSID and IP address
●
in "Network information" .
● WIFI does not support hot plug, do not plug WIFI at boot time
76
Network
Network setting
Network information
Zigbee setting
Exit Move Next
Network
Network setting
Network information
Zigbee setting
Exit Move Next
LAN Network setting
DHCP On
IP address 192 . 168 . 1 . 100
Subnet 255 . 255 . 255 . 0
Gateway 192 . 168 . 1 . 1
Set Cancel
------
选择
Exit Move Select
.
Next
Next