Rear Terminals - Eiki LC-XN200 Owner's Manual

Rear Terminals

① DVI-D
Connect the DVI digital output signal to this
terminal.
② HDMI
Connect digital output signal from HDMI to this
terminal.
③ USB-B
Connect one end of B type USB cable to this
terminal and the other end to a computer to
project the computer screen.
④ USB-A
- Connect A type USB device (e.g. USB flash
drive) to this terminal (Support FAT File System).
- WiFi dongle to this terminal.
⑤ LAN
When using wired network to control and operate
the projector, connect the wired network cable to
this terminal.
⑥ VGA IN 1
Connect output from the source signal from
computer to this terminal.
⑦ VGA IN 2/VGA OUT
- Connect output signal from computer to this
terminal.
- Output the signal from ⑥ to other monitor.
⑧ S-VIDEO IN
Connect S-Video signal to this jack.
⑨ AUDIO IN
Connect the audio signal output to this jack.
① ② ③
⑭ ⑬ ⑫ ⑪
⑩ RS-232C
⑪ R(Pr/Cr)/G(VIDEO/Y)/B(Pb/Cb)/H/V
⑫ R/C OUT
⑬ R/C IN
⑭ ZIGBEE
Part names and functions
④ ⑥
⑩ ⑤ ⑨ ⑧ ⑦
When using RS-232C serial commands to control
or operate the projector, connect the serial cable
to this terminal.
Set "Standby mode" in "Setting" menu as "Normal"
and set "Zigbee mode" in "Zigbee setting" in
"Network" menu as "OFF".
- Connect RGBHV (5BNC) signal to R, G, B, H
and V jacks respectively.
- Connect composite video signal from video
device to G(VIDEO/Y) terminal.
- Connect component signal to Y,Pb/Cb,Pr/Cr.
When using this output port, the output is
completed by connecting the wired remote control
cable to the wired remote control input port of
another device.
When using wired remote control, connect the
wired remote control cable to this port.
The wireless remote control is disable after
inserting the wired remote control cable to either
the remote control or R/C in terminal.
Transmit wireless short-distance signal.
Please insert the rubber gasket (supplied) into
this jack to prevent static electricity when the
ZIGBEE function is not used. When using
the ZIGBEE function, Please insert the Zigbee
antenna.
11