Install Remote Control Batteries; Remote Control Operating Range; Remote Control Code - Eiki LC-XN200 Owner's Manual

Install remote control batteries

① Open the battery
compartment lid.
To ensure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked in the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if two batteries are replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.

Remote Control Operating range

Point the remote control toward the projector
remote receiver (front and back) when pressing
any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees.

Remote Control Code

The ten different remote control codes (Code
0 - Code 9) are assigned to this projector.
Switching the remote control codes prevents
interference from other remote controls
when several projectors or video equipment
next to each other are operated at the same
time. Change the remote control code for the
projector first before changing that for the
remote control. See "Remote control" in the
Setting Menu on page 57.
Press and hold the OK and any number button
(0-9) for more than five seconds to switch
among Code 0 - Code 9.
The initial code is set to Code 0.
② Install new batteries
into the compartment.
Remote control
LED indictaor
Part names and functions
③ Replace the
Two AA batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins
in the compartment.
OK
Numbers
LED indictor on the
remote control will flash
twice after the code is
successfully set.
Setting
Remote Control
Code 0
Code 1
Code 2
Code 3
Code 4
Code 5
Code 6
Code 7
Code 8
Code 9
Exit Back Move ----
compartment lid.
Press and hold
the OK and any
number button
(0-9) for more
than five seconds
to switch among
Code 0 - Code 9.
3/3
Select
15